Table of Contents
Advertisement
System Installation Manual
GFK-2736B
Removal
Mounting/removing devices
Figure 47 Mounting a terminal
When removing a terminal, proceed as shown in Figure 48 on page 88:
•
Disconnect the power to the station.
•
If there is a labeling field, which covers several connectors, it may have to
be removed (detail A1).
Important
If a terminal has several connectors, all connectors of the terminal must be
removed. The following describes how a 2-slot terminal is removed.
•
Lift the connector of the terminal to be removed by pressing on the back
connector shaft latching (detail A2).
Important
When using extended double signal connectors (long connectors), please
ensure that you do not bend them back too far, as you may break the front
snap-on mechanism.
•
Remove the connector (detail B).
•
Remove the adjacent connectors of the neighboring terminals (detail C).
This prevents the potential routing knife contacts and the
keyway/featherkey connections from being damaged. You also have
more space available for accessing the terminal.
Section 9
Feb 2022
87
Advertisement
Table of Contents
