Advertisement
et
|
scenes
lanemienesasiniinnatansebe
enya
ansihentnetnairheetenaminntendilinlncabyteweneeho
een tine
ecein
37
SS BEFORE CALLING SERVICE PERSONNEL
Check the following symptoms before requesting service.
' TV broadcast cannot be received | ¢ "L1", "L2"or "SA" is displayed in
..Channels.on: the TV are not
pet ¢ The: VTR:is not set to AY bast
| rece ee wher he VTRi is on. oe with. "Swi ar
ene
' The NICAM broadcast cannot be | * "NICAM ON/OFF' is not set
No function and no play.
.
° The power cable i is not plugged
° Insert it firmly into the mains outlet.
: The. VTBR does. not. work.even
* There is:no cassette.in the
e Load.a cassette.
though the power is turned on.
VTR. |
15
jr
The colon between the hour and | * There was a short power failure. | ¢ Set the clock.
:
4 , minute digits blinks in the VTR
an
;
display.
12
a
—
=
A TV picture is not good.
* The TV station is not tunedin
| * Adjust it with the TV's fine tuning control.
precisely.
>
° The video channel is not set
* Set a video channel precisely.
correctly.
9
¢ The antenna cable is
..|.¢ Connect it again:
es
ih
disconnected.
9,10
¢ The TV signal is weak.
¢ Adjust the antenna direction or use an
antenna booster (not supplied).
* The power cable of the VTR is
¢ Insert it firmly into the mains outlet.
not plugged in.
¢ Press the INPUT SELECT button so. that the
using the buttons onthe VTR.
' |
the VTR display.
position number appears.
¢ The VTR is not set to VTR
* Press the TV/VIDEO button to make the
cern
mondo
Lo MOMS with "SW" set.
"VIDEO" indicator appear in the VTR display.
¢ Press the: TV/VIDEO. button to make the
» "VIDEO" indicator rdieappeat | in the' VTR™
"display.
* Set "NICAM" to "ON" on the SET UP screen.
received.
correctly.
* NICAM reception is not
'available in your area.
¢ Check with dealer.
-
Recording cannot be performed.
| * The safety tab of the cassette is | » Use a cassette with a safety tab or cover the
removed.
tab hole with adhesive tape.
15 .
A picture being recorded cannot
| *, The VTR is not set to VTR
* Press the TV/VIDEO button to make the
be seen on the TV.
mode with "SW? set.
"VIDEO" indicator appear in the VTR display.
25
A picture is not obtained from the | « "SA" is not displayed in the VTR | « Press the INPUT SELECT button to make
connected satellite receiver.
display.
_ "SA" appear.
26
Advertisement
