Advertisement
fs PLAYBACK
This section explains the basic playback operation.
e Playback
¢ Select the video channel or video input mode on
When playback starts, the VTR automatically
the TV:
adjusts the tracking for clear pictures and sound.
* Set the VTR/TV selector to "VTR".
ne "DT" indicator blinks during the adjusting.
PLAY
Load a recorded cassette. Power is turned on.
@ ;
If the cassette has no safety tab, playback starts
automatically.
c
ha
SR
Bk hs
tS
a I
Notes
;
* During the adjusting, the playback picture and. sound
Se
may be distorted.
[go>
e The digital auto tracking is activated only in the playback
mode.
& Adjusting the tracking manually
If the VTR cannot locate the best. possible tracking
Press the PLAY button to start playback.
ya
point, hold down one of the.CH/TRK buttons until
you obtain the. best possible picture and sound.
aT
CSET
Semen
TaS corres
r e n e
ere bene
a
;
VIDEO
(A)
|
|
a
/
CHITAK
.
om
od
dic
22
eo
lio
tai
Notes
:
* To reset the tracking point to the center, press both the
CH/TRK buttons simultaneously.
.
.
* To resume the digital auto tracking, hold down both the
©
CHANNEL butions on the VTR simultaneously for about 2
:
seconds.
* The noise on the screen may not be completely eliminated
depending.on the tape used, eepecially' when the tape was
recorded on another VTR.
To stop playback, press the STOP button.
Mi To rewind, press the REW button in the stop
mode.
+ | @
}
|
ae
@ To fast-forward, press the FF button in the stop
A.SELECT button to select desired sound output.
=]
mode.
The [L] [R] indicators in the-VTR display tell you what
i
This unit's Hi-Fi stereo audio track (2-channel) can be
used to playback an excellent Hi-Fi sound. Sound that
has been recorded on the normal audio track is
compatible with conventional VTR's.
When playing back a Hi-Fi recorded tape, press the
kind of sound output you are selecting. Accordingly,
you can select the desired sound output while
observing the lit and/or unlit indicators. (See page 24,
"Monitoring Sound Output".)
Note
TVs connected via SCART cables normally select the
video input mode automatically when the PLAY button is
:
The VTR can output sounds, mixing one on the Hi-Fi
:
pressed.
:
stereo audio tracks and one on the normal audio track.
|
|
|
i
|
This function enables you, for example, to record your
voice on a Hi-Fi recorded tape ("Audio Dubbing', page 35).
Press the A.SELECT button several times to make
13
"MIX" appear in the VTR display.
Playback and recording with the LP tape speed
When playing back a tape that has been recorded on
another VTR, it may happen that the picture colour
17
Advertisement
