Using The Charger - Manson Engineering Industrial LBC-6140 Operation Manual

Using the charger

After checking for the correct ac voltage on the rating label and connection to AC supply,
3 digits LED scroll displaying the voltage and current after displaying the version
The default battery type Lithium is on showing charger is in good working condition.
Press and hold the SET button until the 3 digits LED display flashing, the charger now
goes into the setting MENU.
Remark: The charger will back to the normal operation automatically after 30 seconds in
case no further action or selection. Any selection without confirmation will not save into
the charger.
1. Battery Type and DC source Selection Procedure:
In the setting menu, the display shows "Lit" that means the battery types and DC source
selection mode. Each short press will change the mode and battery type in cyclic order.
Lit→LFP→DCS→Lit→....
Just stop at your desired battery type or DCS, press and hold the SET button for 3
seconds to next setting mode.
2.1 In case the battery type (Lit or LFP) is selected, you can set the Float charge
ON/OFF
Press and hold the SET button until display "Lit" or "LFP" NOT flashing, the display
will show "FLT". Short press the SET button will change the "ON" and "OFF" in
cyclic order ON→OFF→ON→... Just stop at your desired selection, press and
hold the SET button until the display not flashing and then goes to the next setting
mode.
2.2 In case "dCS" is selected, you can set the output voltage
Press and hold the SET button until display "dCS" not flashing, the display will
show the voltage value.
a. The first step is to set the unit digit of output voltage value. While unit digit
flashes press SET button to change by 1V Steps: 12.8→13.8→14.8→12.8.
b. Press and hold the SET button to confirm the unit digit value and enter into
decimal value setting of 0.1V steps.
c. Press SET button to change by 0.1V steps.
13.0→13.1→13.2→13.3→13.4→13.5→13.6→13.7→13.8→13.9→13.0→...
Press and hold the SET button to confirm and then goes to the next setting
mode the charging current.
3. Charging current setting
The display will show the current setting. Short press the SET button can change the
charging current value in cyclic order. 40→4→10→20→40→...
Just stop at your desired value, press and hold the SET button until the set value not
flashing.
All settings completed and the charger will back to the normal operation
automatically.
WiFi setting (WiFi/ Bluetooth version only)
Bluetooth is available to be connect in factory default. Use Smartphone app from
AppStore or Google play to connect charger using Bluetooth first. The charger
Bluetooth name is start with "mbt". After connected with Bluetooth, it can configure WiFi
connection within apps.
P.4