Troubleshooting - inventum IKA8045 User Manual

1. Put a container below one of the rubber plugs at the bottom of the appliance.
2. Pull out the rubber plug with one hand and hold the container with the other hand to drain the liquid.
3. Ensure the drainage hole is not blocked and put the plug back into place. Press the plug in tightly.
4. Repeat steps 1 to 3 for the second rubber plug.
5. Remove any objects that might have fallen in from above, and wipe out the inside of the appliance with soapy
water and a dish cloth.
6. Dry the cavity and re-insert the grease filter and the grille.
REPLACING THE CARBON FILTERS (OPTIONAL)
Note:
The carbon filers must be replaced when the display shows FC or every 6 months.
Note:
This procedure is only valid if you installed the carbon filters with your appliance.
1. Remove the grille and the grease filter.
2. Replace the carbon filters.
3. Install the grease filter and the grille.
RESETTING THE SATURATION INDICATOR
The appliance gives an alarm on the display for certain cleaning and replacing intervals, such as replacing the
carbon filters.
1. Make sure that the appliance is switched off.
2. Touch and hold the child lock button for 3 seconds to enter the lock modus.
3. Touch and hold the button for extraction system for 3 seconds to reset the saturation indicator. The operation
indicator shows "CL".
8

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the breakdown codes.
2. If you cannot find a solution for the problem or the breakdown code keeps re-occuring, contact Inventum-
servicedienst
TROUBLESHOOTING TABLE
Problem
The induction hob does not start.
The operation indicator on the
control panel of the induction hob
shows U.
(Figure 6)
Possible cause
There is no mains supply.
The child lock is activated.
The touch buttons are covered with
water or dirt.
There is no pan on the cooking zone. Put a pan on the cooking zone.
Possible solution
• Do a check if the mains plug is
correctly connected to the mains
socket.
• Make sure that the mains supply
is on.
Deactivate the child lock. Refer to
Locking and unlocking the
section
appliance .
Clean the appliance. Refer to section
Daily cleaning
.
English • 39