Overview Usage Instructions After assembling the board, connect it to your drone’s power source and configure it using the Speedybee APP installation guide. The board supports INAV / Ardupilot firmware and can be used to control motors and servos with the motor and servo output pin header. The board also includes a buzzer, USB TYPE-C port, buzzer mute switch, FC RGB status indicator, and a BOOT button.
Dimension: 52cL x 32cW x 19cH mm Weight: 35g with USB extender Wireless Configuration: Supported LED Strip Controller: Supported Battery Level Indicator: Supported Product Name SpeedyBee F405 WING APP TOP Board SpeedyBee F405 WING Wireless Board FC Board SpeedyBee F405 WING FC Board PDB Board...
Assembly order 1. Align the pin headers between boards A and B then press the two boards together tightly. 2. Install both boards A and B onto board C, and tighten the screws. Refer to the diagram for assembly order: Hardware description FC Board Front...
Page 8
Wireless status indicator (RGB LED) The wireless board has built-in telemetry function , which includes 4 RF modes: Bluetooth BLE, Wi-Fi, classic Bluetooth SPP, and wireless off mode.w Green: low power Bluetooth BLE mode. White: Wi-Fi mode. Blue: classic Bluetooth mode. The RGB LED is off: wireless off...
Firmware upgrade and APP connection Firmware upgrade SpeedyBee F405 WING APP not supporting wireless firmware flashing, please update the firmware on a computer. Follow these steps: 1. Press and hold the BOOT button , and connect the FC to the computer via USB cable.
Connecting INAV Firmware to Speedybee APP. Check the color of the wireless status indicator . If it’s slow flashing green, open the SpeedyBee app and follow the steps to connect to the corresponding product. Documents / Resources...
Need help?
Do you have a question about the F405 WING APP and is the answer not in the manual?
Questions and answers