Other Site Requirements - U-Line Origins 1115R Installation Manual

7. Relocate plastic spacer/bushing (Figure 8) on bottom
of door to opposite side, and place door on bottom
hinge pin. Clean out bushing hole in door bottom with
a screwdriver if necessary.
Plastic
Plug Hole
Right Side
Door Swing
Right Side
Hinge
Figure 9
8. Remove plastic hole plug (Figure 9) from door handle
and relocate on opposite side.
9. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge.
Figure 10
10. Remove three plastic screw plugs (Figure 10) from
hinge holes, top of cabinet, opposite side. Be careful
not to scratch cabinet.
11. Place door on lower hinge pin. Invert and install upper
hinge on door.
Figure 11
07/2006
1115R and 1115WC Models
Hinge
Plastic
Plug Hole
Screw
Left Side
Door Swing
Invert Invert
Screw Hinge
ULIN_0142_A
ULIN_0144_A
ULIN_0145_A
12. Fasten upper hinge to unit (three screws) (Figure 11).
Partially tighten screws.
13. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
14. Replace three plastic plugs removed in Step 10 into
holes on top of unit. Replace screws in holes in bottom
of unit on opposite side.
15. Replace the grille and grille cap. Be sure to place grille
cap on opposite side of unit from where it was
originally.

Other Site Requirements

Power Supply
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A circuit (normal household current). See
Electrical Specifications on Page 10.
Environmental Requirements
Many U-Line models are designed to operate in harsh
outdoor/marine environments. Special considerations
include the following:
(1115R REFRIGERATOR requirements)
• The units are designed to operate between 50°F (10°C) and
110°F (40°C). High ambient temperatures (110°F [40°C] or
higher) may reduce the unit's ability to reach low
temperatures and may also reduce the ice production rate
for those models with icemakers.
• If the ambient temperature is expected to drop below 45°F
(7°C), drain all water from the unit to prevent freezing
damage not covered by the warranty.
• For best performance, keep the unit out of direct sunlight
and away from heat generating equipment.
• For best performance and life outdoors, place under a
counter or provide shelter of some kind.
• In climates where high humidity and dew points are
present, condensation may appear on outside surfaces. This
is considered normal. The condensation will disappear when
the humidity drops.
(1115WC WINE CAPTAIN
• The units are designed to operate between 50°F (10°C) and
110°F (40°C). High ambient temperatures (110°F [40°C] or
higher) may reduce the unit's ability to reach low
temperatures.
• For best performance, keep the unit out of direct sunlight
and away from heat generating equipment.
• In climates where high humidity and dew points are
present, condensation may appear on outside surfaces. This
is considered normal. The condensation will disappear when
the humidity drops.
• U-Line does not recommend installation of glass front
models (Wine Captain
Centers) as well as the Combo Drawer model (Refrigerator/
Freezer/Ice Maker) outdoors, or in tropical climates where
high humidity and dew point are present on a regular basis,
unless air-conditioning (typical 72°F, 75%RH) will be used.
7
®
requirements)
®
wine storage models and Beverage
www.U-LineService.com