• Proper installation procedures must be followed when completing an installation or relocation of a unit. Consult the installation guide before any installation begins. U-Line contact information appears on the rear cover of this guide. • This unit requires connection to a dedicated 15 Amp...
3 Inspect & Plan Product Registration You have received a carton containing your U-Line Wine Captain®, Refrigerator, or Beverage Center with a package inside containing a Use and Care Guide and a Product Registration Card. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
4 Prepare Site Your U-Line product has been designed for either free-standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for an electrical connection in the rear.
6 Door Swing Dimensions All units have a zero clearance for the door to open 90°. U-Line recommends a minimum door clearance of 2" to accommodate the handle if the unit is installed next to a wall or similar type of structure.
1. Remove bottom hinge from cabinet. Some models will have a Plastic gusset with two screws. Other models will have a plate with three screws. 2. Remove corresponding screws on opposite side of cabinet. On U-Line Standrd Door Alignment and Reversal...
Page 10
5. Remove the plastic hinge bushing (2) and install in the corner opposite of where it was removed. 6. Remove the U-Line nameplate (3) from door. This will reveal mounting holes for the door actuator bracket. 7. Remove door actuator (4) from door. Be sure to only remove the two screws holding the actuator to the door.
5. Lightly sand and reapply if desired. Allow the final coat to dry for 24 hours before reinstalling the trim to the cabinet interior parts. U-Line Wood Trim Finishing IMPORTANT IMPORTANT ® ®...
7. Install two small screws removed in Step 3. 8. Starting at the corners and working inward, push door gasket into place on door. 9. Place door on bottom hinge pin and install upper hinge screw. U-Line Door Panel Installationl IMPORTANT IMPORTANT...
10 Installation Leveling Information It is recommended that the unit is level. 1. Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown 2.
E-mail: onlineparts@u-line.com ABOUT U-LINE Building on 45 years, U-Line has captivated those with an appreciation for the finer things with exceptional design, inspired innovations and attention to even the smallest details. U-Line is synonymous with premium built-in under counter ice making, refrigeration and wine storage appli- ances, the U-Line Corporation is committed to luxury under the counter.
Need help?
Do you have a question about the ADA24RG and is the answer not in the manual?
Questions and answers