U-Line Echelon 2075DWRRSS User Manual page 26

User's Manual
The temperature will be the air temperature in the unit and
NOT the temperature of your product. The temperature may
be higher or lower than your set point; this is the normal air
temperature when maintaining a STABLE product tempera-
ture. Wait at least an hour to check the unit again before
changing set point.
To check the actual temperature in the ice compartment, press the
WARMER button momentarily, and then press and hold "COOLER" for 3
seconds.
The ice compartment set temperature is 0°F and cannot be
set. The temperature may vary while cycling or when the unit
is in the self defrost mode. The temperature may adjust itself
slightly up or down to match the refrigerator set point if it
changes from 38°F. The temperature will be the air temper-
ature and may vary between +10°F and –10°F. During defrost
or after loading product, the temperature may appear higher
temporarily.
Refer to Table 2 to determine indicator light status.
LED Status
1 • Solid
• Flashing
2 • Solid
• Flashing
Table 2. Indicator Light Status -
NOTE
NOTE
Indicates
• Refrigerator Temperature displayed
• Not Applicable
• Freezer Temperature displayed
• Open Thermistor – call for service
26