U-Line 2115RSOD Use And Care Manual page 19

To reverse the door:
Remove door:
1. Hold door to keep it from falling.
2. Remove hinge screw pin (1) from top hinge using a Phillips
screwdriver.
3. Remove door by tilting forward and lifting door off bottom hinge
closer inserts.
4. Reinstall hinge screw pin (1) into top hinge using a Phillips
screwdriver.
Remove hole plugs.
Remove plastic screw plugs (three each, top and bottom) (3)
from new hinge location. Save for reinstallation later.
Remove existing top hinge.
Remove existing top hinge (three screws) (2).
Reinstall hinge to bottom opposite.
1. Install the hinge just removed from the top to the BOTTOM
opposite side of the cabinet (three screws) (2).
2. Remove the two door closer inserts (4) from the existing
bottom hinge.
3. Install door closer inserts as shown on the new bottom hinge
(4).
Remove existing bottom hinge.
Reinstall hinge to top opposite.
Reinstall Hole Plugs.
Install plastic screw plugs (three each, top and bottom) (3) into
holes where hinge hardware was removed.
Prepare door for reinstallation.
1. Remove plastic hole plug from top of door handle and reinstall
2. With bottom of door facing up, remove pivot plate (5) (two
3. Flip over and install pivot plate on opposite side of door. Ensure
Install Door.
1. Hold door upright and tilted forward.
2. Lift door on to bottom hinge closer inserts.
3. Tilt door forward into position.
4. Hold door to keep it from falling.
5. Reinstall hinge screw pin (1) into top hinge using a Phillips
Align and adjust the door:
U-Line Self-Closing Door Alignment and Reversal
Remove the existing bottom hinge (three screws) (2).
Install the hinge just removed from the bottom to the TOP
opposite side of the cabinet (three screws) (2).
1
on opposite side.
screws).
notch in plate faces center.
screwdriver.
Align and adjust the door, see DOOR ALIGNMENT AND
ADJUSTMENT above.
17