Maintenance - Husqvarna DM1 PACE Operator's Manual

2. Use the wrenches to remove the drill bit.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.

Maintenance

Make sure that movable parts function correctly and
move freely.
Make sure that the cutting tool is sharp and clean.
Make sure that the control panel operates correctly and
that it is not damaged.
Make sure that the start/stop button operates correctly.
Make sure that the handles and holding surfaces are
dry, clean and free of oil and grease.
Make sure that the product is clean.
Clean the air intake on the product.
Examine the shaft seals for damage/water leakage.
Make sure that the screws are tight.
Replace the gear oil.
Do a check of the connections between the battery and
the product. Do a check of the connection between the
battery and the battery charger.
Blow through the product and battery cooling slots care-
fully with compressed air.
18
Maintenance
Read and understand the
Remove the battery before
3. Lubricate the tool thread with water resistant grease.
4. Use the wrenches to attach the new drill bit.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Speak to a Husqvarna service agent.
Before After
each use each use
*
*
X
X
* *
X X
X X
X
After the
Weekly
first 100 h
*
O
X
*
1941 - 005 - 25.09.2023
After
each 300
h
X