Using The Appliance - universalblue NESS PLUS 6039W User Manual

ENGLISH
the refrigerator in a space where the
temperature ranges from 16ºC to 38ºC
Stacked installation or side by side. If you
want to install two refrigerators, one on top
of the other or one next to the other, there
must be at least 150mm between them.
The Refrigerator must be installed on a
completely flat surface; leave between 5
and 10 cm on both sides of the appliance,
7,5 cm between the back part and the
wall and 10 cm between the top part of
the appliance and the ceiling. A wrong
positioning could lead to increasing the
noise level.
It is possible to install certain appliances
without a minimum distance. Check with
an authorized dealer or kitchen designer.
Reversible door
The side on which the fridge door can
opens can be switched from right to left
sidem if required by your installation place.
Follow the instructions below to make the
change. (see the sequence of pictures in
figure 2 on page 5):
• Remove the top tight hinge cover.
• Lift the freezer door to release it from
the centre hinge and place it gently to
one side on a padded surface.
• Using a screwdriver, remove the centre
hinge, lift the fridge door to disengage
it from the hinge and set the door aside
on a padded surface.
Replace it on the opposite side and place
the supplied replacement hinge screw in
the parts bag:
• Remove the upper left hinge cover parts
from the bag and install on the left side,
tightening all screws.

USING THE APPLIANCE

To make the most of your product, please
read the following food placement tips
36
carefully:
• There should always be space between
foods to allow air to circulate.
• Food should
packaging to prevent it from drying out
or smelling bad.
• Hot food should be cooled before
being placed in the fridge. Otherwise,
the temperature will rise and energy
consumption will increase.
• Reducing the number of times the door
is opened is an effective way to reduce
power consumption.
• The temperature in the refrigerator
can be controlled manually using the
control knob. However, please note that
the number displayed on the knob does
not directly represent the temperature,
as it depends on external factors such
as the number of times the refrigerator
door is opened.
Control panel
On the side of the interior of the refrigerator
compartment, you will find a control knob
that allows you to control the temperature
range you require (refrigerator and the
fridge are controlled together)
Before first use
Before using the appliance, remove all
wrappings, including corks and rubber
straps. Adjust the feet and wipe the outside
and inside of the cooler with a warm cloth.
Do not start the refrigerator immediately
after installation, it should be started after
2-6 hours of standing to ensure proper
operation. To prevent damage to the power
cord and any consequential incidents, the
power cord must not be covered by the
appliance itself or other objects. Before
turning it on, please check if the voltage
range of the refrigerator is the same as that
of the power supply. When the refrigerator
is installed for the first time, allow it to
stabilise at normal operating temperatures
for 2-3 hours before filling it with fresh
or frozen food. If operation is interrupted,
wait 5 minutes before restarting.
Please note that
be kept in airtight
the refrigerator