universalblue JAVA 5045W User Manual page 45

The minimum permissible
•
inlet water
0.04MPa.
CARACTERÍSTICAS Y PARTES DEL
PRODUCTO
See image 01 on page 4 to view the parts of
the product.
1. Inner pipe
2. Lower spray arm
3. Salt container
4. Filter assembly
5. Dispenser
6. Cutlery basket
7. Cup rack
8. Upper spray arm
9. Cutlery rack
10. Lower basket
Note: the images are indicative, there may
be differences with the product purchased.
For product features please refer to table 01
on page 12.
To make room for taller items
in the upper basket, raise the
cup rack upwards. You can then
lean the tall glasses against
it. You can also remove it when it is not
required for use.
ASSEMBLY AND INSTALLATION
Installation
connections must be carried
out only
professionals.
Disconnect
before installing dishwasher.
Failure to do so could result in
death or electrical shock.
For personal safety: do not use
an extension cord or adapter
plug with this appliance. Don
not, under any circumstances
pressure is
of electrical
by authorised
electrical power
cut or remove the earthing connection
from the power cord.
Electrical requirements
Please look at the rating label to know the
rating voltage and connect the dishwasher
to the appropriate power supply. Use the
required fuse 10A/13A/16A, time delay
fuse or circuit breaker recommended and
provide separate circuit serving only this
appliance.
Electrical connection
Ensure the voltage and frequency of the
power being corresponds to those on
the rating plate. Only insert the plug into
an electrical socket which is earthed
properly. If the electrical socket to which
the ppliance must be connected is not
appropriate for the plug, replace the socket,
rather than using a adaptors or the like as
they could cause overheating and burns.
Ensure that proper earthing
exists before use
WATER SUPPLY AND DRAIN
Cold water connection (see image 02 on
page 4)
Connect the cold water supply hose to a
threaded 3/4(inch) connector and make
sure that it is fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is
clear. This precaution is needed to avoid
the risk of the water inlet to be blocked and
damage the appliance.
About the safety supply hose
The safety supply hose consists of the
double walls. The system guarantees its
intervention by blocking the flow of water
in case of the supply hose breaking and
when the air space between the supply
hose itself and the outer corrugated hose is
full of water.
EN
45