Advertisement
Available languages
Available languages
For model USM3106-23 (See picture 1 on
page 4):
1. Door.
2. Safe locking.
3. Inner cavity.
4. Wave dispenser.
5. Locking system.
6. Door handle.
7. Display.
8. Control panel
9. Control knob.
10.
Glass tray
11. Rotary ring
12. Light.
For model USM3107-23/USM3108-3 (see
picture 2 on page 4):
13. Safe locking.
14. Inner cavity.
15. Wave dispenser.
16. Locking system.
17. Screen.
18. Door.
19. Glass tray
20. Rotary ring
21. Light.
22. Control panel
23. Door button.
To see the characteristics of the product
you can see the table 01 on page 9.
ASSEMBLY AND INSTALLATION
This
product
does
complicated
installation
process.
Before
proceeding
product, memorize the position of every
accessory, in case you need to pack it up
again in the future.
Remove
material, labels and/or stickers
on the product. Make sure there
is no trace of the packaging
material in the burners or in the
grid, this could cause damages or fired
not
require
any
or
assembly
to
unpacking
all
the
packaging
• If the appliance is damaged, please
contact
purchased.
• The manufacturer is not responsible
for damage to the product caused by
improper installation.
• Before using the product for the first
time, remove the protective film from
all parts.
• Place the unit on a flat, stable surface.
• The ventilation slots at the rear, top and
bottom must be free.
• The unit is supplied ready to plug into
a properly installed and grounded wall
outlet.
• Only a qualified electrician should
reposition the socket or change the
connection cable.
• The socket on the unit must always be
accessible.
• Do not use multiple socket strips or
extension cords as this may cause
electric overload.
• Make sure that the voltage and
frequency is the same as indicated on
the product label.
Keep in mind that both the
assembly and other aspects
may vary depending on the
model purchased.
Do not install the appliance on
a hob or other heat-producing
appliance. If installed near or
over
appliance may be damaged and
the warranty will be nulled.
the
Installation (see picture 07 on page 8)
• Select a smooth, level surface that
provides sufficient open space for the
exit holes.
• The
minimum
surface
to be installed must be 85 cm.
The
must be placed against a wall.
Leave
the
store
where
a
heat
source,
height
where
the
appliance
rear
of
the
a
minimum
EN
it
was
the
of
the
is
appliance
clearance
29
Advertisement
