Installing The Batteries.8 - Sony Ruvi CCD-CR1 Operating Instructions Manual

Installing the batteries
Before using your camcorder, you first need to install two size AA (LR6) Sony batteries
or the charged battery pack. Use the supplied size AA (LR6) Sony batteries or the NP-
RO "InfoLITHlUM" battery pack (S seriese).
When you install or remove the batteries, be sure to turn off the camcorder to prevent
misoperation of the camcorder.
You can also use house current as a power source. (P. 10)
0) To open the lid of the battery compartment, slide the OPEN (BATT) release
lever at the bottom of the camcorder to the left, then slide it toward you and
release.
(2) Install two size AA (LR6) batteries or the battery pack in the direction of the
arrow. Then close the lid and slide it until it clicks.
Note on size AA (LR6) batteries
• Be sure to install two size AA (LR6) batteries with correct polarity.
• You can not use size A A (LRh) batteries in a cold environment. Use the NP-RO battery
pack
Battery life
When using two size AA (LR6) Sony batteries or the NP-RO rechargeable battery pack:
Battery
Size AA (LR6) batteries NP-F10
Continuous recording
time*
M) minutes
40{80) minutes
Typical recording time** TO minutes
50 (45) minutes
Playing time on LCD (•>() minutes
40 (80) minutes
Numbers in parehthese: s of NP-RO indicate the time when you use a norm'affy charged
battery.
* Approximate continuous recording time at 77°F (25°C). Battery life will be shorter if
you use the camcorder in a cold environment.
** Approximate minutes when recording while you repeat recording start/stop and
turning the power on/off. The actual battery life may be shorter.