Advertisement
(0-1)
This camcorder uses a lithium battery to
activate the clock and to keep a title in
memory. Before operating it for the first time,
install the supplied lithium battery.
1° Pull out the tithium battery holder from the
bottom of the camcorder.
2 Install the supplied CR2025 lithium battery
with the + side facing the other side.
3 Put the lithium battery holder back into the
camcorder.
To change the fithium battery
Pull out the lithium battery holder from the
camcorder, and remove the lithium battery and
insert a new one.
Note on battery life
The battery lasts for approximately 1 year under
normal operation. When the lithium battery
becomes weak, the time indication blinks in the
viewfinder for about 5 seconds when POWER
is set
to CAMERA. When this happens, replace the
battery with a Sony CR2025 or Duracell DL-2025
lithium battery. Use of another battery may present
a risk of fire or explosion. While replacing the
lithium battery, keep the battery pack or other
power source attached. If the battery pack or other
power source was not attached while replacing,
readjustment of the date and time is necessary.
Cautions
* Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
consult a doctor immediately.
* Wipe the battery with a dry cloth to assure good
contact.
* Be sure to install the battery with the correct
polarity.
* Do not hold the battery with metallic tweezers,
as a short-circuit may occur.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble, or dispose of it in a fire.
17
Advertisement
