Cleaning the Unit
Close the front door.
• Push both sides of the front door
down gently until it clicks into place.
• Do not close the front door holding
the hopper extension tray.
Close the ADF door.
• Push both sides of the ADF door
down gently until it clicks into place.
• If the ADF door proves difficult to
close, push its left side down with a
little more force.
• After cleaning, clear the "Clean Roller
Warning" display.
(See page 18.)
• Re-attachment of the white sensor roller
When the white sensor roller is removed while cleaning the inside of the scanner, re¬
attach it as shown below.
Lower white sensor roller:
Attach the roller by placing the gear
side to the left side of the scanner
and inserting both side's bearings
into the guide grooves.
• Match the flat side of the bearing with
the flat side of the guide groove.
• After attaching, press down on top of
the white sensor roller with your finger
to confirm if it moves or not.
36