ADJUSTMENTS
This set has been aligned at the factory and normally will not require further adjustment. As a result, it is not
recommended that any attempt is made to modificate any circuit. If any parts are replaced or if anyone tampers
with the adjustment, realignment may be necessary.
IMPORTANT
1. Check power-source voltage.
2. Set the function switch to band being aligned.
3. Turn volume control to minimum unless otherwise noted.
4. Keep the signal input as low as possible to avoid AGC and AFC action.
TEST & ADJUSTMENT POINT
Figure 1. MAIN P.C.BOARD
VR805
VR804 [suco
Loi
VR803 EEixe!
VR802 ar:
Figure 2. CD P.C.BOARD