Adaptec AHA-1540C User Manual page 74

Using the Configuration Software
Note
You must not remove removable-disk cartridges from the
drive while your computer is running when using this
option.
III
If you want the ability to remove disk-media cartridges
from their drives while your computer is running, you
must install additional software. Refer to Chapter Five,
I/O Operating Environment Software.
Using Removable Boot Disk Cartridges as a Security Lock
Removable disks configured as boot devices can be used to lock
your system when they are removed. To do this:
Format a removable-disk cartridge and partition it to be a sys-
tem boot device.
2: Make sure no other boot device is installed on your system.
3 Insert the boot cartridge before powering-up the system and
remove it after you shut it down.
4l Your system then will have no boot device when the cartridge
is removed, and cannot be used without it.
Dynamically Scan SCSI Bus for BIOS Devices
This option is Disabled by default.
When this option is Enabled, the Ignore In BIOS Scan option
appears on the SCSI Device Configuration screen.
Enable this option to access and boot from disk drives set
to any SCSI ID, from 0 to 7.
e When this option is Disabled, SCSI boot drives must be
set to SCSI ID O.
BIOS Support for More Than 2 Drives (MS-DOS(R) 5.0 and above)
This option is Disabled by default.