Flextiny Ii Modules - Star FL3X Interface-PMC Instructions For Use Manual

Signaling
Permanent red
lighting of all LEDs
Flashing of all LEDs
Red flashing
Red and green
lighting at the same
time
Green lighting
Green flashing
Table 10: Description of indicating LEDs

3.5.5 FlexTiny II Modules

The FL3X Interface-PMC hardware provides four FlexTiny II connectors. There FL3X Interface-PMC hardware
version 0A01 and 0A02 has connectors which colored beige.
When inserting the FlexTiny II module check for correct insertion. Check if the marking
"inside" is showing to the text "inside" on the FL3X Interface-PMC and the text
"Frontpanel" is showing to the connector side.
Created by STAR ELECTRONICS GmbH & Co. KG
Date created 2023-02-08
Mounted
FlexTiny II
Signals a buffer overflow on the internal RAM.
Any
Any
Signals an error in the FlexRay communication controller (e.g.
FlexRay
FlexRay communication controller is not synchronized but
connected to an actively working network. Bus traffic is detected.
FlexRay This LED combination is active when monitoring in asynchronous
The intensity of the LEDs is dependent on the traffic on the bus.
CAN
The intensity of the LEDs is dependent on the traffic on the bus.
FlexRay communication controller is synchronized.
FlexRay
The intensity of the LED is dependent on the traffic on the bus.
Ethernet
Signals the FlexRay communication controller is in a startup state
(that means that the FlexRay communication controller is ready for
FlexRay synchronization). This can be seen when monitoring in normal
mode and the FlexRay configuration is incorrect or no cable
Ethernet
Date modified
Description
The fallback firmware image is running.
clock correction errors).
mode.
Bus traffic is detected.
The Ethernet link is active.
connected.
Bus traffic is detected.
NOTICE
2023-02-08 Page 20 of 38