Graco LineLazer GM 3500 Instructions-Parts List Manual page 22

Trigger Cable
& Dual
Gun
Selector Operation
Trigger Cable Tension Adjustment
See Fig.
21
1. Relieve pressure. See page 7.
2.
Be sure the gun is properly mounted in the holder as
instructed on page 20.
3. Pull the actuator lever (94) fotward and hold it. L i i up
on the gun trigger (A) until there is
sbgtd
resistance.
Visually check to see if there is about 1/32 to 1/16 in.
gap between the trigger lever (B) and where the gun
trigger touches the bar.
4. T o adjust the tension, loosen the screw (C) in the
block (48). Slide the block forward to increase the
gap and backward to decrease the gap. Ttghten the
Be
sure end jacket of cable
screw.
seats here. keep jacket and
5. Recheck the gap and adjust as needed.
A
CAUTION
Do
not allow the cable
(402)
to rub against the
outside edges of the slot (H) in the block
(M), to
prevent premature wear of the cable. Rotate the
Fig. 21
block slightly to eliminate rubbing. See Fig.
21
DETAIL A.
22 308-082