Dantherm Flexibox 810 indoor Service Manual page 27

Changing parameters,
System Control The fifth section in the parameters file is covering overall system parameters controlling
Configurations any various system events
System Control Configurations
1.Norm. Vdc Low Level
2.Norm. Vdc High Level
3.Temp Alarm Low Limit
4.Temp Alarm high Limit
5.Delta T
6.Alarm1 NO/NC Type
7.Alarm2 NO/NC Type
8.Alarm1 delay sec
9.Alarm2 delay sec
10.Dig.1 NO/NC Type
11.Dig.2 NO/NC Type
12.Door Xtch. NO/NC Type
13.Filter Grd NO/NC Type
14.Phase Monitor NO/NC Type
15.Status Log Dis/Ena.
16.Log interval in min.
17.RS-485 Bus Pow. Dis/Ena
18.ModBus Slave Addr
The table below explains each parameter
Temp Alarm Low Limit
3.
Temp Alarm high Limit
4.
Alarm1 NO/NC Type
6.
Alarm2 NO/NC Type
7.
Dig.1 NO/NC Type
10.
Status Log Dis/Ena.
15.
Log interval in min.
16.
.RS-485 Bus Pow.
17
Dis/Ena
18. ModBus Slave Addr
Only parameters in this above table are to be changed!
continued
[TL][(-40)-80]: 0.0
[TH][(-40)-80]: 50.0
[Dt][(-40)-80]: 3.0
[Alm1 delay][0-100]: 10
[Alm2 delay][0-100]: 10
Parameter
The lower alarm trigger limit
The upper alarm trigger limit
Change between NO (normally
open) and NC (normally close)
contact configuration
0=NO and 1=NC
Change between NO (normally
open) and NC (normally close)
contact configuration
0=NO and 1=NC
Change between NO (normally
open) and NC (normally close)
contact configuration
0=NO and 1=NC
SD card logging active
Logging interval on SD card
RS485 power out. Disable if using
J17/ RS-485 with non Dantherm
display.
Set the device adresse if having
more devices in order to avoid
address conflicts
[V1][18-60]: 40
[V2][18-60]: 60
[Àlm1][0/1]: 0
[Alm2][0/1]: 0
[Dig1][0/1]: 0
[Dig2][0/1]: 0
[Door][0/1]: 0
[Filt][0/1]: 0
[PHm][0/1]: 0
[Log][0/1]: 1
[Int][1-60]: 1
[0/1]: 1
[1-255]: 23
Function Dependencies
Alarm mapping see
page 26
Alarm mapping see
page 26
Alarm mapping see
page 26
Alarm mapping see
page 26
SD card needs to be
inserted
Continued overleaf
25