Flexibox Installation - Dantherm Flexibox 810 indoor Service Manual

Flexibox installation

Introduction
Placement
Enclosed installation
parts
Preparation
8
The Flexibox unit needs proper installation in order to operate flawless for many years.
Please follow this section for proper installation
The Flexibox is designed to be inside any enclosure, as low as possible.The damper
needs to be located as close as possible to the ceiling and optimal as far away from the
Flexibox as possible.
The following parts for installation are included:
Usage
Flexibox
Earth connection
Internal hood
Controller
Sensor
To be able to place screws in the back
cover plate, the front cover and filter
needs to be removed.
Please turn the illustrated sheet metal, for
making a wall hanging bracket
Part
Screws ø4,8x38mm
Rawlplugs ø8x40mm
Hex bolt M8x16mm
Lock washer M8
Screws ø4x12mm –TX 20
Plug 2-way (power)
Plug 3-way
Plug 4-way
Plug 8-way
Sensor, metal housing, 2600 mm cable
Cable clamp, plastic
Screws for clamps, ø4,2x13mm
Amount
15
15
1
1
8
1
1
1
1
1
2
2
Continued overleaf