Dantherm Flexibox 810 indoor Service Manual page 12

Flexibox installation,
Mount Flexibox
Ambient temperatu-
re sensor
10
continued
Mount the unit by flowing below procedure:
Step Action
Lift the unit onto the bracket,
1 and fix is momentarily with a
plier
Secure the Flexibox thru the four
holes in the rear plate of the
2
unit, to the wall structure. Pre-
drill holes if needed.
Remount the filter and front cov-
3
er.
Route and install the outdoor temperature sensor, through the wall cut out, and place it
outside, underneath the hood
Illustration
Fig. 5
Continued overleaf