Aiwa NSX-SZ70 Operating Instructions Manual page 18

PROGRAMMED EDIT RECORDING
MULTI JOG CD EDIT/CHECK
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape.
NOTE]
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
7 Insert the tape into deck 2, and press DOLBY NR
to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice.
When using the remote control, press CD EDIT/CHECK twic«
while pressing SHIFT.
"EDIT" and "PRGM" are displayed.
¢ When "Al' is displayed, press CD EDIT/CHECK again.
4 Press numbered buttons on the remote contro
to designate the tape length.
10 to 99 minutes can be specified.
° The <<, > or MULTI JOG are also available to designate
the tape length.
Tape length Tape side A (front side)
Maximum recording
time for side A
5 Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press numbered buttons 0-9 and +10 or
the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and 0.
Remaining time Programmed
Selected track number on side A tracks
Program number
18 ENeusH
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK to select side B and
program the tracks for side B.
After confirming "B" on the display, repeat step 5.
Tape side B (reverse side)
8 Press @REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press MJ. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press << or »P repeatedly.
Programmed track
Disc number =' Track number numbers