Serial Port Selection - Equinox Systems Micro-ISP IV Series User Manual

The Micro-ISP programmer plugs into a
spare serial (com) port of any IBM
compatible PC including the majority of
laptop machines.
To select the Correct Serial Port
i. From the menu bar select <Options>
<Select Port>
The available COM ports on your computer
are now displayed.
ii. Select the COM port to which the
programmer is connected
ii. Select a baud rate e.g. 56K
iii. Select <Test>
A programmer communications test is now
performed.
This tests both the programmer, cable and
PC serial port.
Test Programmer
Checking Port
Checking Communication
Checking Communication
Select Communication Port
Port :
Speed :
Micro-ISP
Serial Port Selection (Select Port)
: Pass
:
:
Cancel
COM2 Test
56000
Cancel
OK
IV User Manual V2.03
Series
Communications Test Pass
The programmer has been detected OK by
the Meridian software. If you now <Cancel>
out of the <Test Port> dialogue box, the
words 'ON LINE' should now be displayed at
the bottom right of the
Micro-ISP Window.
Installation is complete and the programmer
should now be ready to-use.
Communications Test Fail
The programmer was not detected on the
COM port selected. Please check that the
correct COM port was selected, and if not,
repeat the <Select Port> < Test> operation.
If your PC is not fast enough to operate at
the default highest communication speed,
it may be necessary to slow the
communication down. This can be achieved
by choosing a slower baud rate from the list
provided.
If the programmer is still not detected,
please refer to the Installation
Troubleshooting Guide located in the
"On-Line" help.
8