Table of Contents
Advertisement
3NH
2. Release two wire saddle.
3. Remove the connector A.
4. Remove two screws and remove the rear
cover mount and bush.
5. Remove the PF paper feed clutch 1.
6. Remove the connector B.
7. Remove three claws and remove the
clutch holder.
8. Remove the PF paper feed clutch 2.
9. Replace each clutch.
10. Refit all removed parts.
When fitting the clutches, be sure to refit
the whirl-stops.
1-5-8
Wire saddle
Wire saddle
Connector A
Connector B
PF paper
feed clutch 2
Claw
Claw
Service Manual
PF paper
feed clutch 1
Bush
Rear cover mount
Screw
Clutch holder
Claw
Clutch holder
Figure 1-5-13
Screw
Y112350-4
Advertisement
Table of Contents
