Panasonic SA-HE200 Operating Instructions Manual page 11

Change the settings to suit your speakers and units to the environment in which you are using them. Belore making any changes, read the
descriptions of the settings, note the factory settings and ranges, and refer to the equipment's instructions.
©
FILTER
E
D-INPUT
Digital input
©
Adjusting speaker output level
Change the cut-off for bass
output from the front speakers
If you set the front speakers to
"SMALL", the filter is set to 100 Hz.
Raise the cut-off if the bass from the
front speakers is unsatisfactory so
that this bass is output through the
subwoofer.
You can raise the cut-off from 100 Hz
to either 150 Hz or 200 Hz.
Change the settings based on the
table you completed on page 4 so that
the correct source is selected when
you turn [INPUT SELECTOR],
The factory settings are:
TV: OPT 1
DVD: OPT 2
DVR: OPT 3
CD-R/RW: OPT 4
CD: COAX
Adjust the level of the other speakers based on the output of the
front speakers. (Speakers set as "NONE" or "NO" are skipped.
Adjust the volume of the front speakers with [VOLUME}.)
C (center), SR (surround right), SB (surround back)(SBR-
surround back right- and SBL-surround back left- when DUAL
selected), and SL (surround left) can be adjusted between -10 dB
and +10 dB, with 0 being the level of the front speakers.
Adjust center, surround and surround back output to the same
apparent level of the front speakers.
For SW (subwoofer), you can select "—" so there is no output,
"MIN" for minimum output, a level between 1 and 19, or "MAX" for
maximum output.
Adjust subwoofer output so it is balanced with the front speakers.
Subwoofer output is easily influenced by the source. You can also
change its level while playing something for better effect
(-► page 15).
Preparation: Turn SPEAKERS A on.
/_ /_ t t T (\ I I
t i t t t i v 11
Output the signal.
Two seconds each.
."SINGLE" L-C -R — SR-SB-SI—SW
t-1
"DUAL" L —
C-*-R-*SR-* SBR-* SBL — SL— SW
Select.
Select.
Adjust the main volume.
Select.
TV, DVD, DVR,
CD-R/RW, CD
Change.
Change.
Select the speaker channel.
Adjust the level.
100, 150, 200
OPT 1, OPT 2, OPT 3,
OPT 4, COAX
Stop the test signal.
The "SURROUND" DSP mode is engaged.
RQT6250