Electrical Connections - Zanussi ZMB 32 CT Instruction Manual

liliireii
Electrical connections - UK • ••
• Check the power voltage. If there is a PERMANENT under¬
voltage, consult your electrical installer.
• Your installation must be protected by a thermal fuse
13 Amp (UK), 10 Amp (AUS & NZ).
• In your electrical installation, provide a device that is acces¬
sible to the installer, capable of separating the appliance from
the mains power and whose contact opening is at least 3 mm at
all of the poles.
• Never operate the oven if the supply cord or its plug are damaged.
In this case, call in a specialized technician trained by the
manufacturer.
WARNING
l
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety
measure not be observed.
If the plug that is fitted to your appliance is not suitable for
your socket outlet, it must be cut off and the appropriate plug
fitted.
Remove the fuse from the cut off plug. The cut off plug
should then be disposed of to prevent the hazard of shocks in
case it should be plugged into a 13 Amp socket in another part
of your home.
IMPORTANT
The wires in the mains lead are coloured in accordance with
the following code:
GREEN AND YELLOW EARTH
blue neutral
BROWN LIVE
If you fit your own plug, the colours of the wires in the mains
lead of your appliance may not correspond with the markings
identifying the terminals in your plug; proceed as follows:
Connect the green and yellow (earth) wire to the terminal in
the plug which is marked with the letter "E" or the earth
symbol (^^) or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug
which is marked with the letter "N" or coloured black.
Connect the brown (live) wire to the terminal in the plug
which is marked with the letter "L" or coloured red.
The plug moulded onto the lead incorporates a fuse. For
replacement, use a 13 Amp BS1362 fuse. Only ASTA or BSI
approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The
cover/carrier is indicated by the coloured insert at the base of
the plug. A replacement cover/carrier must be obtained from
your local Zanussi Service Centre.
9