Advertisement
For easier storage and for transporting the appli¬
ance, slide the floor cleaning head or foe ROTO-
SOFT1000 Turbo-brush into, the storage rail.
When foe paper dustbag is full or blocked or any of foe accessories are blocked the
over-heating protection for foe motor isactivated. Switch off and unplug the vacuum
cleaner and allow foe motor to cool down.
Check foe pape r dustbag and accessories and remove any blockages. The cleaner
can be switched on again after 30 minutes.
...the fuse blows or trips?
It you connect other electrical appliances with a high wattage to the same mains cir-
cuit and use them at foe same time as foe vacuum cleaner, this can trip the fuse.
This can be avoided if you set the electronic power control to 250W before you
switch on, and only select a higher output level after switching on.
...the thread-collectors are worn out?
If foe thread-collectors (B) at the suction opening
are worn out or stuck together, you can fit ones.
They can be ordered from the AEG Service Centre
under the ET-No. 668 900 560.
...the wheels of the floor cleaning head are
hard to move?
Remove any hairs or threads which have become
wrapped round the axle of the roller. The wheels
can be removed for cleaning. Pull roller (A) as illus¬
trated. Remove hairs and threads. When replacing
it, the semi-circular axle-head must point inwards. If the'roller axle is inserted wrong
way round the swivel joint could suiter damage.
6
i
|
i
i
i
i
I
a
i
I
I
I
Advertisement
