Table of Contents
Advertisement
24
| Transportation and storage
For easier storage and for transporting the appli-
ance,
slide the floor cleaning
head
or the
ROTOSOFT 1000 Turbo-brush into the storage rail.
What to do when...
... the motor protection is activated?
When the paper dustbag is full or blocked or any
of the accessories are blocked the
over-heating protection for the motor is activated. Switch offand unplug the vacuum
cleaner and allow the motor to cool down.
Check the paper dustbag and accessories and remove any blockages. The cleaner
can be switched on again after 30 minutes.
5
... the fuse blows or trips?
lf you connect other electrical appliances
with a high wattage to the same mains cir-
cuit and use them at the same time as the vacuum cleaner, this can trip the fuse.
This can be avoided if you set the electronic power control to 250 W before you
switch on, and only sélect a higher output level after switching on.
... the thread-collectors are worn out?
if the thread-collectors (B) at the suction opening
are worn out or stuck together, you can fit ones.
They can be ordered from the AEG Service Centre
under the ET-No. 668 900 560.
...the wheels of the floor cleaning head are
hard
to move?
Remove any hairs or threads which have become
wrapped round the axle of the roller.
The wheels can be removed for cleaning. Pull roller
(A) as illustrated. Remove hairs and threads. When
replacing it, the semi-circular axle-head must point
inwards. If the roller axle is inserted wrong way
round the swivel joint could suffer damage.
2/TA1
9/91
GB/EU
- 2/WW1
9/91
GBVEU
- 2/WW2
9/91
GB/EU
- 2/WW4
9/91
GBVEU
- 2/WW5
9/91
GB/EU
Advertisement
Table of Contents
