Advertisement
1. Wipe the cabinet with a mild household
detergent. Avoid using abrasive cleaners.
2. Clean the lint filter after every drying cycle.
3. If the filter mesh is dirty, dean it with a soft
brush.
4. Clean the heat exchanger at least every three
month proceeding as follows:
* Open the door and press the button on the
bottom of the aperture.
e The heat exchanger flap opens.
¢ Lift slightly the heat exchanger and remove it.
e Flush the heat exchanger under running
Note: The heat exchanger plates may discolour
water.
with use.
Should your dryer operate incorrectly, check the
e Has the start button been pressed?
following points before calling for a service
e Has the drying programme been selected?
Ee
Lint filter or water indicator light on
Drying is too long / clothes are not dry
e Js the lint filter clean?
¢ Have you selected the correct programme?
¢ Were the inserted clothes too wet (Spin
speed less than 800 rpm)?
e |s the lint filter dirty? (warning indicator on)
e {|s the heat exchanger clean?
Replacing light bulb
If the interior light does not work, the bulb may
perhaps be faulty.
e Unplug dryer!
¢ Open door and unscrew glass cover inside
The dryer does not operate:
the drum.
e Has the fuse blown?
suitable up to 300° C.
e |s the door closed?
lf after the above checks your appliance does
not work properly, get in touch with the
nearest After-Sales Service Centre.
Please give:
e ashort description of the fault.
e the exact model of the appliance.
e the service number visible on the right
when door is open.
RES
WAKAS
0000 000 00000
HT
* your correct address and telephone
number.
19
Advertisement
