Noise And Vibration; Technical Data - Flex PD 2G 18.0-EC HD Original Operating Instructions

■ Use suitable detectors to detect
concealed power supply cables or
consult your local supply company.
Contact with electric cables may result in
a fire and/or electric shock. A damaged
gas pipe may cause an explosion. Cutting
into a water pipe will cause damage to
property.
■ Switch off the power tool immediately
when the cutting accessory jams. Be
prepared for high reaction torques
which cause kickback. The cutting
accessory jams when:
– the power tool is overloaded or
– it snags in the workpiece to be
machined.
■ Maintain a firm grip on the power tool.
High reaction torques can occur briefly
when screws are tightened and released.
■ Secure the workpiece. A workpiece is
held more securely in a clamping device or
vice than by hand.
■ Wait until the power tool has come to a
stop before putting it down. The cutting
accessory may snag, causing the operator
to lose control of the power tool.
■ Use only original batteries with the
voltage indicated on the type plate
of your power tool. The use of other
batteries, e.g. imitations, reconditioned
batteries or other makes, increases the
risk of injury and damage to property by
exploding batteries.
■ Wear ear defenders when impact drilling.
The effect of noise may result in loss of
hearing.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
PD 2G 18.0-EC HD
DD 2G 18.0-EC HD
– Sound power level L
PD 2G 18.0-EC HD
DD 2G 18.0-EC HD
– Uncertainty:
Total vibration value :
– Emissionswert a
14
:
pA
89.1 dB(A)
82 dB(A)
:
WA
100.1 dB(A)
90 dB(A)
K = 5 dB.
:
h,D
PD 2G 18.0-EC HD / DD 2G 18.0-EC HD
PD 2G 18.0-EC HD
DD 2G 18.0-EC HD
– Emission value a
PD 2G 18.0-EC HD
– Uncertainty:
CAU TION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organisation of work patterns.
CAU TION!
Wear ear defenders at a sound pressure
above 85 dB(A).

Technical data

Tool
Type
Torque settings
2.5 m/s 2
<2.5 m/s
2
, :
h ID
16.5 m/s
2
K = 1.5 m/s
PD 2G 18.0- DD 2G 18.0-
EC HD EC HD
Percussion
Drill driver
drill driver
23 21
2