Noise And Vibration; Technical Data - Flex PD 2G 18.0-EC-HD Original Operating Instructions

■ Secure the workpiece. A workpiece is
held more securely in a clamping device or
vice than by hand.
■ Wait until the power tool has come to a
stop before putting it down. The cutting
accessory may snag, causing the operator
to lose control of the power tool.
■ Use only original batteries with the
voltage indicated on the type plate
of your power tool. The use of other
batteries, e.g. imitations, reconditioned
batteries or other makes, increases the
risk of injury and damage to property by
exploding batteries.
■ Wear ear defenders when impact drilling.
The effect of noise may result in loss of
hearing.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
– Total vibration value (when polishing
painted surfaces):
– Emission value a
– Uncertainty:
CAU TION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
14
: 93 dB(A);
pA
: 104dB(A);
WA
K = 3 dB.
: 3.24 m/s
h
K = 1.5 m/s
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organisation of work patterns.
CAU TION!
Wear ear defenders at a sound pressure
above 85 dB(A).

Technical data

Tool
Type
Torque settings
Max. torque
No-load speed r.p.m 0-550/2000
TURBO speed
Impact rate
2
TURBO impact
2
rate
Chuck
Max. drill
diameter
– in wood
– in steel
– in masonry
Weight
according
to"EPTA
Procedure
01/2003"
(without battery)
PD 2G 18.0-EC-HD
PD 2G 18.0-EC-HD
Percussion drill
driver
23
Nm 70/158
r.p.m 0-700/2500
bpm 0-8800/32000
bpm 0-11200/40000
mm 13
mm
89
mm
13
mm
16
kg 1.68