Operation - Dexter Laundry 12ID2-25.1A Original Instructions Manual

-The declared vibration total value and the declared noise emission value have been measured in
accordance with a standard test method and may be used for comparing one tool with another.
- The declared vibration total value and the declared noise emission value may also be used in a preliminary
assessment of exposure.
- Evitați riscurile asociate vibrațiilor
- Avoid vibration risk.
Suggestion:
1) wear glove during operation
2) limit operating time and shorten trigger time

OPERATION

EN
WARNING : The device should be disconnected from the mains before putting into operation
BIT INSTALLATION
When selecting a drill bit, use the right type for your job. For best performance, always use a sharp drill
bit.
1. To open the chuck jaws, holdits collar while turning the sleeve in the counter clockwise direction.
Insert the drill bit deeply into the chuck, and then center the bit in the chuck jaws.
2. To close the chuck jaws, hold the collar while turning the sleeve in the clockwise direction.Tighten
securely.
3. Remove the drill bit in reverse order.
NOTE: The chucks of reversible drills are always fixed by a screw with a left hand thread. The screw must be
loosed before the chuck can be removed if necessary. To loosen the screw, turn it in a clockwise direction.
FORWARD / REVERSE ADJUSTMENT
1. For forward (clockwise) rotation, push the forward /reverse switch to the left position.
2. For reverse (counterclockwise) rotation, push the forward/reverse switch to the right position.
Although an interlock prevents reversing the tool while the motor is running, allow it to come to a
full stop before reversing.
WARNING: If the forward / reverse switch is in the central position, the tool can not be switched on.
SELECTING THE IMPACT / DRILL MODE
The impact/drill switch should be set according to the type of action required.
The tool has two settings:
- Drill mode : For drilling into wood and metal. Use standard drill bits.
- Impact mode : For drilling into stone and masonry. Use masonry drill bits.
VARIABLE SPEED TRIGGER SWITCH
WARNING: Always check that the power supply is the same as that indicated on the nameplate of
the tool.
This tool has a variable speed switch which can reach higher speed with increased trigger pressure. Speed
is controlled by the pressure to the switch trigger. The variable speed feature is particularly useful when
starting drilling. It also enables you to select the best speed for a particular application.
To limit the maximum speed of the tool, rotate the dial on the front of the trigger until the desired setting
is achieved. Turn the dial to the"+" direction to increase the speed and to the "-" direction to decrease the
speed.
NOTE: It is recommended to use the variable speed feature for a short time only. Do not continuously
operate the tool at different speeds. It may damage the switch.
102