Technical Data; Operation - Dexter Laundry 500HD2.5 Original Instructions Manual

TECHNICAL DATA

Type designation
Rated voltage
Rated power input
Speed, n
0
Max. collet diamater
Drilling capacity
-- in steel
-- in wood
Level of acoustic pressure L
Level of acoustic power L
Level of vibration
Machine Net Weight:
WARNING :
The vibration and noise emissions during actual use of the power tool can differ from the declared values depending
on the ways in which the tool is used especially what kind of workpiece is processed;
The emissions value need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to the trigger time).
Note:
- The declared vibration total value and the declared noise emission value have been measured in accordance with
a standard test method and may be used for comparing one tool with another.
- The declared vibration total value and the declared noise emission value may also be used in a preliminary
assessment of exposure.
- Avoid vibration risk.
Suggestion:
1) wear glove during operation
2) limit operating time and shorten trigger time

OPERATION

WARNING : The device should be disconnected from the mains before putting into operation
BIT INSTALLATION
When selecting a drill bit, use the right type for your job. For best performance, always use a sharp drill bit.
1. To open the chuck jaws, holdits collar while turning the sleeve in the counter clockwise direction. Insert the
drill bit deeply into the chuck, and then center the bit in the chuck jaws.
2. To close the chuck jaws, hold the collar while turning the sleeve in the clockwise direction.Tighten securely.
3. Remove the drill bit in reverse order.
NOTE: The chucks of reversible drills are always fixed by a screw with a left hand thread. The screw must be loosed
before the chuck can be removed if necessary. To loosen the screw, turn it in a clockwise direction.
(K =3dB(A))
pA pA
(K =3dB(A))
wA wA
Drill into steel: K=1,5 m/s
(Acc. to EPTA 01/2003)
2
500HD2.5
220-240V~ 50Hz
500W
0-2800min
-1'
Ø10 mm
10 mm
22 mm
96,0 dB(A)
107,0 dB(A)
a = 7,370 m/s
2
h,D
1,28 kg
EN - 77