Troubleshooting - Dexter Laundry 12ID2-25.1A Original Instructions Manual

A. INSPECTING THE MOUNTING SCREWS
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the
screws be loose, tighten them immediately. Failure to do so could result in serious injuries
B. MAINTENANCE OF THE MOTOR
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does
not become damaged and /or wet with oil or water
C. INSPECTION OF THE CARBON BRUSHES (for brushed model only)
The motor employs carbon brushes which are consumable parts. Since excessively worn carbon results in
motor trouble, replace the carbon brush with an identical part when it becomes worn to or near the limit.
In addition, always keep carbon brushes clean and ensure that they slide freely within the brush holder.
TROUBLE SHOOTING
PROBLEM
PRODUCT DOES NOT START
THE MACHINE STOPS WORKING
AFTER ROTATING SLOWLY
UNUSUAL VIBRATION DURING USE
SPARKING VISIBLE THROUGH THE
HOUSING AIR VENTS
UNSATISFACTORY RESULT
STORAGE AND TRANSPORTATION CONDITION
STORAGE
This product :
- must be stored in a dry place
- must be stored away from sources of high temperatures and exposure to sunlight
- must avoid sudden temperature changes during storage
- must be stored without packaging is not allowed
- must be stored in the manufacturer's packaging in warehouses at an ambient temperature of +0 to
+40°С. Humidity should not exceed 80%.
TRANSPORTATION
This product :
- must be transported in closed vehicles in accordance with the rules for the carriage of goods in force on
POSSIBLE CAUSE
Not connected to power supply
Other electrical defect to the
product
The battery is low power
Air vents are blocked
The battery is low power
Bit is not well assembled
A small amount of sparking may be
visible through the housing vents
Drill bit is worn or not adapted to
the material to drill
SOLUTION
Connect to power supply
Check by a specialist
electrician
Need to charge the
battery pack before
operating
Clean the air vents
Need to charge the
battery pack before
operating
Disassembly and
assembly the drill bit
by strictly following
instructions
This is normal and does
not indicate a problem
Replace with new bit or
check the compatibility
between drill bit and
material to drill
EN
105