HermanMiller Canvas Office Landscape In-Line Beam Connector Installation And Disassembly For Recycling Instructions
  1. Manuals
  2. Brands
  3. HermanMiller Manuals
  4. Office Equipment
  5. Canvas Office Landscape In-Line Beam...
  6. Installation and disassembly for recycling instructions
HermanMiller Canvas Office Landscape In-Line Beam Connector Installation And Disassembly For Recycling Instructions

HermanMiller Canvas Office Landscape In-Line Beam Connector Installation And Disassembly For Recycling Instructions

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

Y

Parts Included:

A
Coupler Assembly (2)
D
Ganging Plate (1 or 2)

Tools Required:

Rachet Wrench 1/2" Hex Socket
Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Canvas Office Landscape
Installation and Disassembly for Recycling Instructions
B
Hex Socket Button
Head Screw (16)
E
Pan Head
Screw (16)
Hardware Pack
Torque Wrench
3/16 Allen Wrench
In-Line Beam Connector
®
C
Hex Nut (16)
Hardware Pack
Safety Glass
Part no. 1b6y34 rev B.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Canvas Office Landscape In-Line Beam Connector and is the answer not in the manual?

Questions and answers

Related Manuals for HermanMiller Canvas Office Landscape In-Line Beam Connector

Summary of Contents for HermanMiller Canvas Office Landscape In-Line Beam Connector

  • Page 1 Canvas Office Landscape In-Line Beam Connector ® Installation and Disassembly for Recycling Instructions Parts Included: Hex Socket Button Hex Nut (16) Head Screw (16) Hardware Pack Coupler Assembly (2) Pan Head Screw (16) Hardware Pack Ganging Plate (1 or 2) Tools Required: Torque Wrench 3/16 Allen Wrench...
  • Page 2 Shim Here If Needed 1. Mate 2 Beam Frames together on Floor. 2. Insert Coupler(A) into Frames with groove side down. 3. Install 8 Hex Socket Button Head Screws(B) and 8 Hex Nuts(C) per Coupler. 4. Place straight edge on top op beam at joint. If there is a gap between straight edge and top of beam then place shims under beam until frame is flat or has a slight crown.
  • Page 3 Support 6. Install Coupler onto ajoining Frame Assembly, then supported Frame Assembly. 7. Place straight edge on top of Frame at joint. Adjust levelers on Supports until frames are flat or has slight crown. 8. Tighten screws to 30 ft/lbs. 9.
  • Page 4 Disassembly and Recycling: Materials Identification and Segregation: Where possible, plastic components are marked with ASTM recycling codes. Use these codes to identify material type for recycling. Non marked components should be treated as mixed plastic. Ferrous metals can be identified using a small magnet for recycling.

Table of Contents