Polaris RANGER 150 EFI 2020 Owner's Manual page 93

3. Shorten or lengthen the tie rod until alignment is as required to achieve the
proper toe setting as specified in above.
When tightening the tie rod end jam nuts, the rod ends must be held parallel to
prevent rod end damage and premature wear. Damage may not be
4. After alignment is complete, torque jam nuts to specification.
VEHICLE IMMERSION
If your vehicle becomes immersed, major engine damage can result if the
machine is not thoroughly inspected. Take the vehicle in for service before
starting the engine. Your POLARIS dealer can provide this service.
If it's impossible to take your vehicle to a dealer before starting it, follow the
steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. If water is present, dry the air box and replace the filter
with a new filter. Thoroughly dry the air pre-filter..
3. Remove the air box drain plug to drain any water. Reinstall the drain plug
securely.
4. Remove the spark plug.
5. Turn the engine over several times using the electric start.
6. Dry the spark plug and reinstall it, or install a new plug.
7. Attempt to start the engine. If necessary, repeat the drying procedure.
8. Take the vehicle in for service as soon as possible, whether you succeed in
starting it or not. Your POLARIS dealer can provide the required service.
9. If water has been ingested into the transmission follow the procedure in the
Constant Variable Transmission (CVT) System section for details on drying.
IMPORTANT
immediately apparent if done incorrectly.
TORQUE
Tie Rod Jam Nut:
13 ft-lbs (18 Nm)
NOTICE
MAINTENANCE
91