Bracket Replacement - NEC N8104-224 User Manual

2.1. Bracket Replacement

Depending on the type of system, installation of this product requires either a standard bracket or a low-profile
bracket. NEC provides both of these brackets with the product. By default Full Height bracket is attached. Please
replace the bracket according to the following steps as necessary.
1.
Remove screw on this product with a screw driver.
2.
Remove the attached bracket and install the other bracket. Please keep the removed bracket.
3.
Attach the bracket with the bracket fixing screw.
When attaching / detaching the bracket, move the bracket in the direction shown in the following figure.
N8104-178
Detach
Attach
Memo.
N8104-180/181/209
Detach
1
As shown in the figure on the left side of the figure below,
Rotate the bracket toward the arrow and remove it.
Bracket
LAN port
E-16
N8104-179/224
Attach
Align the "raised dot" on the LAN port to the "hole" on the bracket.
Hole
Raised
dot
Rotate the bracket toward the arrow and attach it.
Bracket
LAN Port