Precautions; Foatuips - Onkyo TX-930 Instruction Manual

Precautions
Se
1.
Warranty Card
The serial number is written on the rear panel of this unit. Copy the
serial number and model number onto your warranty card and keep
it in a safe place.
® Voltage Selector (Rear Panel)
Worldwide models are equipped with a voltage selector to conform
with loca! power supplies. Be sure to set this switch to match the
voltage of the power supply in your area before turning the power
2. Recording Copyright switch on. Voltage is changed by sliding the groove in the switch
Recording of copyrighted material for other than personal use Is with a screwdriver to the right or left. Confirm that the switch has
illegal without permission of the copyright holder. been moved all the way to the right or left before turning the power
3. AC Fuse switch on. Models without a voltage selector can only be used in
The fuse is located inside the chassis and is not user serviceable. areas where the power supply is the same as that of the unit.
lf power does not come on, contact your Onkyo service center.
4. Care
From time to time you should wipe off the front and rear panels and
the cabinet with a soft cloth. For heavier dirt, dampen a soft cloth
in a weak solution of mild detergent and water, wring it out dry, and
wipe off the dirt. Following this, dry immediately with a clean cloth. | oO Cn) |
Do not use rough material, thinners, alcohol or other chemical
solvents or cloths since these could damage the finish or remove
the panel lettering. 220V 120V% 220V %\ 120V %
WARNING
BEFORE TURNING ON POWER FOR THE FIRST TIME, READ © Tuning Step Frequency Switch (Bottom)
THE FOLLOWING SECTION CAREFULLY. g step F r e q u e n c y s . ,
® Some models are designed for use only with the power supply Worldwide models are equipped with a switch that controls the AM
(9 kHz/10 kHz} and FM (50 kHz/200 KHz) band tuning steps.
voltage of the region where they are sold. ;
Be sure to set this switch to match the tuning step frequency in your
European models area
K.): AC2 (except UK): — -AG2SV, 80 Hz U.S.A.and Canada 10 kHz/200 kHz
U.S.A. and Canadian models: AC120V. 60 Hz Other area 9 kHz/50 kHz
U.K. & Australian models: AC240V, 50 Hz
Worldwide models: 120 and 220V switchabie,
50/60 Hz
Features
a
@ Plenty of Clean Power
TX-930: 60 watts of continuous power per channel into 8 ohms with no more than 0.2% total harmonic distortion (2 x 100 watts DIN power at 4 ohms)
TX-910: 45 watts of continuous power per channel into 8 ohms with no more than 0.3% total harmonic distortion (2 x 80 watts DIN power at 4 ohms)
® Discrete Output Stage
Instead of the less expensive IC power amp circuitry used in some receivers, the TX-930 and TX-910 feature output stages composed of discrete
components. Not just an off - the - shelf chip, the circuit design of the output stage is optimized for the specific requirements of the tuner amplifier
to assure that the TX-930 and TX-910 can not only deliver sufficient power, but also safely drive even low impedance loads.
40-Station FM/AM Random Preset Tuning
Classified Memory Preset
The memory presets are divided into six classes, A through F, which can be used for different types of programs (rock, news, classical, etc.).
Or each member of the family can have a separate class (class A for Dad, class 8 for Mom, class D for Junior). Any preset station can be assigned
to any class. When you press a classified scan button, the tuner provides a sample of each station in the selected class.
@ Direct Access Tuning Using Numeric Buttons
Instead of using the UP or DOWN tuning buttons to scan through the available frequencies until the desired station is located, Direct Access Tuning lets you
punch in the broadcast frequency directly using the numeric buttons. For example, 103.5 MHz can be selected by simply pressing the 1, 0, 3 and 5 buttons.
@ APR (Automatic Precision Reception) System
Onkyo's exclusive APR system lets every FM broadcast sound its best. Its built - in electronic brain monitors the signal and selects the optimum
settings for RF local/DX and stereo auto/mono. The APR system settings are shown by indicators on the front panel.
@ Six Program inputs Including Video Sound with Logic Controlled Feather-Touch Keys
@ Two Pairs of Speaker Output Terminals
® Loudness Control
® FI Compatible Wireless Remote Control Included