Onkyo TX-930 Instruction Manual page 8

Tape Deck and Graphic Equalizer Connections (TAPE-1, TAPE-2)
1. This unit has facilities for two tape decks. If you are using only one
tape deck, connect it to the TAPE-1/VIDEO jacks. if you have two
tape decks, connect one to the TAPE-1/ViIDEO jacks and the other
to the TAPE-2 jacks.
2. Connect the output leads of the tape decks to the TAPE-1/VIDEO
and TAPE-2 "PLAY" jacks. Connect the input leads of the tape
decks to the TAPE-1/VIDEO and TAPE-2 "REC" jacks of the unit.
For more details, refer to your tape deck instruction manual.
3. To connect a graphic equalizer, too, use the TAPE-2 jacks and
connect the second tape deck to the tape jacks of the equalizer.
(See the figure)
To connect a graphic equalizer and second tape deck to the
TAPE-2 jacks.
To TAPE-2 "REC" jacks of TX-930/910
To TAPE-2 "PLAY" jacks of TX-930/910
Graphic equalizer
Second tape deck
4. For the audio signal of a VDP, VCR, etc., make the connections to
the TAPE-1/VIDEO "PLAY", "REC" jacks. For details, refer to the
operating instructions of the video equipment concerned.
5. If you have an Onkyo tape deck with the RI remote control jack,
connect it to the TAPE-1/VIDEO jacks. Please refer to the section
"Connections for Remote Control" on 6 page regarding connection
of the remote control cable.
Speaker Connections (SPEAKERS)
1. Connect the speakers to A and/or B terminals.
2. When connecting speakers, proper polarity is important.
Always connect the (+) terminal (red) on this equipment to the (+)
terminal on the speaker and the (—) terminal (black) on this
equipment to the (—) terminal on the speaker.
3. Do not connect a single speaker in paraliel to the right and left
channel outputs.
4. Use speaker cables that have a low impedance and that are as
short as possible.
¢ Attach speaker cables to the rear panei speaker terminals with
care, being sure that connections are made firmly and that there is
no possibility of a short circuit occurring.
AC Outlets (TX-930 only)
@ SWITCHED:
An AC outlet is switched on and off by the Power button on the front
panel and remote control transmitter. Capacity is 100 watts.
Australian model
(TX-930 only) For some areas
L AG QUTLET
SWITCHED DOW MAX
wee ee ee,
Connections for Remote Control (REMOTE CONTROL)
® The upper and lower (RI remote control jacks have the same
function.
® Acassette tape deck and compact disc player that have the Onkyo
fR1 mark can be operated, using the accessory remote control
transmitter.
TX-930/910
'FAL REMOTE (s
CONTAGL
COMPACT
DISC PLAYER
fAl REMOTE
CONTROL
CASSETTE
TAPE DECK
FQ REMOTE é
CONTAGL ©
>
An fR1 remote control cable equipped with a 1/8"
(3.5mm) diameter miniature two-conductor phone plug
is atlached to the TX-930/910 and to any compact disc
player, with the FRYE mark.
To use an Onkyo compact disc player and cassette tape deck with the
fRI mark, insert the accessory remote control cable plug into the
REMOTE CONTROL jacks. As far as connecting sequence is con-
cerned, it doesn't matter whether the cable is connected from the
TX-930/910 to the cassette tape deck or to the compact disc player.
The remote control transmitter is operated by facing it towards the
remote control sensor of the TX-930/910.
NOTE:
Remote contro! operation is not possible when only the remote
control cable is connected. Remote control cable and connecting
cable must be connected.