Hisense PureFlat RB22A2FSE User's Operation Manual page 6

Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need to
be adjusted.You can adjust them
manually by hand or by using a suitable
spanner.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6"(10 -15mm).
0.4" - 0.6"(10 -15mm)
B
A
adjustable bottom feet
Note:
If required you may lay the refrigerator
on its back in order to gain access to
the base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.
Installing the handles
Before you use the appliance, you
have to install the handles provided in
the fridge chamber.
A Adjustable bottom
feet
B Front roller
C Rear roller
C
Tools you will need:
Not provided
Wrench (5/16")
Thin-blade
screwdriver
Thin blade(utility knife e.g. )
Additional parts (in
the plastic bag)
Allen Wrench (5/32")
Upper Hinge-Left
S
crew Hole Cover
right
Left stop Block
The longer one is fridge door handle, the
shorter one is freezer door handle. Please
follow procedures below to install and
reverse the handle.
Take out the screw hole covers on the
doors, install the handle supports 1. Place
the handle 3 and 4 on the doors by fitting
the handle over the handle supports 1,
then fasten the screws 2 with 5/32" Allen
wrench (provided in plastic bag).
Cross screwdriver
Monkey wrench
Upper Hinge
Cover-left
Middle Hinge-left
Left Door Stopper
6