Section 6: Troubleshooting - Grizzly T10718 Owner's Manual

SECTION 6: TROUBLESHOOTING

Review the troubleshooting and procedures in this section if a problem develops with your machine. If
you need replacement parts or additional help with a procedure, call our Technical Support. Note: Please
gather the serial number and manufacture date of your machine before calling.
Symptom Possible Cause
Heavy resistance 1. Machine capacities are exceeded.
during bends.
2. Not enough setback.
Bend radius is not 1. Bending leaf not parallel with clamping leaf.
consistent across
2. Clamping fingers or bending blocks not
workpiece.
properly aligned.
3. Too much setback.
Workpiece moves 1. Clamping pressure not correctly adjusted.
while bending.
2. Not enough pressure applied with foot
pedal.
Model T10718 (Mfg. Since 1/13)
Possible Solution
1. Use sheet metal that does not exceed machine
capacities (Page 4).
2. Properly calculate and adjust setback (Page 14).
1. Adjust bending leaf parallel with clamping leaf.
2. Properly align clamping fingers and bending blocks
(Page 17).
3. Properly calculate and adjust setback (Page 14).
1. Correctly adjust clamping pressure for workpiece
thickness (Page 15).
2. Lock foot pedal down so clamping leaf secures
workpiece.
-23-