Memory Mode; Changing The Temperature Scale - Braun ThermoScan IRT6520B Manual

Memory mode

This model stores the last 9 temperature measurements. To display
1
the stored measurement, the thermometer must be turned on.
2
Press the Mem button.
The display shows the temperature, and when releasing the
Mem button, the stored temperature for that memory number
is displayed, together with "M".
3
Each time the Mem button is pushed, the
stored reading and an M is displayed to
indicate each temperature measurement
(eg. M2).
Memory mode is automatically exited by
not pressing the memory button for 5 seconds.
The last temperature taken is stored in its
memory and will be automatically displayed for
5 seconds when it is turned on again.
Night light feature
The thermometer includes a convenient night light to illuminate the display in
a dim environment.
The light will turn on when you press any button. It will stay on until the
thermometer is inactive for up to 10 seconds even after temperature is taken.

Changing the temperature scale

This thermometer is shipped with the Celsius (°C) temperature scale activated. If you wish to
switch to Fahrenheit (°F) and/or back from Fahrenheit to Celsius, proceed as follows:
1
Make sure the thermometer is turned off.
Press and hold down the Power button
2
display will show this sequence: °C / SET / °F / SET ...
3
Release the Power
shown. There will be a short beep to confirm the new setting, then the
thermometer is turned off automatically.
. After about 3 seconds the
button when the desired temperature scale is
10 sec
8