Advertisement
10. AIR CLEANER
1. Remove the right side cover.
2. Remove bolts and nuts securing the filter in place. Loosen
the band connecting the filter to the carburetor.
3. Move the filter case assembly toward the front to facilitate
removal of the filter cover; take out the cover.
4. Remove the filter element.
5. Clean the element in clean stoddard solvent (solvent) and
allow to dry thoroughly.
WARNING :
Gasoline or low flash point solvents are highly flammable
and must not be used to clean the filter element.
7. Replace the filter element.
8. Install the filter cover.
9. Install the filter case.
11. OIL FILTER
1. Drain the engine thoroughly by removing the drain plug.
2, Remove the muffler, kick starter and right foot rest.
3. Loosen off screws securing the right crankcase cover in
place; take out the cover together with the gasket under
the cover.
4. Pry off the snap ring and remove the filter cap from the
filter rotor.
5. Wipe clean sediments from around center of the rotor
using a lint-free cloth as shown.
6. Assemble
all removed
parts in the reverse order of the
removal. Be sure to replace gasket.
Fig. 2—20
@ Air filter cover
@® Filter attaching bolt
® Filter cover attaching nut @ Band screw
Fig. 2-21
@ Air filterelement
© Filter element attaching band
® Filter element attaching bolt
Fig. 2-22
@ Snap ring
@ Filter cap
Fig. 2-23
@® Oil filter rotor
19
ses
ones
SE
et
EAS
Aer
meen
eNONAN
Advertisement
