During Washing; Changing A Program; Add A Garment / Interrupting The Program; Canceling Active Program - Bosch Nexxt 100 Series Operating, Care And Installation Instructions Manual

Fq
[_lf an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off.
O12h
@3_ @ fill sh/>d
If necessary, press the Delay
Start button until the desired delay
time is indicated by the LED light.
i ,2,
o,,
o,,
__ , @3h O finished
......... g Spin
gw sh
Delay @ d oor locke d
Start
Press the Start/Pause button.
The indicator light is lit (red).
The program starts.
finished
Q spin
(_ rinse
wash
door locked
iF Each program steF s na_ca_eaDy
the corresponding LED light.
During Washing
[_Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
Turn the program selector to Off.
Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
If required, change the settings;
see from Page 16.
Press the Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
F_lt is not recommended to add
laundry after the washing phase is
complete.
F_You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
Press the Start/Pause button.
The Start/Pause indicator light
flashes.
Open the door.
Place/remove the laundry.
Close the door.
Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
[_ When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).
F_lf the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
"Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
Fq
Fq
If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
Turn the program selector to Off.
Turn the program selector to Drain
or Spin.
Press the Start/Pause button.
Wait until this program ends.
Open the door.
Unload the laundry.
If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light goes
out.
Open the door.
_>S 'ermooent Press _ Regular/Cotton
o wa;
Delicate and Wash
Spin _ Soak
Turn the program selector to Off.
Close the taps.
Remove the laundry.
[_ After washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.
17