Table of Contents
Advertisement
CLEANING & MAINTENANCE
CONT'D
7
8
Dry immediately, with a
*It is important to clean the
soft, dry cloth.
appliance and all parts
after each use. This will
prolong the life of your
appliance. All other servicing
or maintenance of the
product must be performed
by Dualit or a qualified
electrical engineer.
26
TROUBLESHOOTING
Possible cause(s)
THE AIR FRYER DOES NOT WORK.
Internal fan does not come on.
The appliance is not plugged in.
You have not set the timer.
The plug fuse may have failed.
CRISPER PLATE DOES NOT FIT INTO THE CRISPER TRAY.
Crisper Plate has the wrong orientation.
Crisper Plate has been lowered into the
Crisper Tray incorrectly.
You installed the Crisper Plate upside down,
so the Ring Pull is on the underside.
CANNOT SLIDE THE CRISPER TRAY INTO THE APPLIANCE PROPERLY.
There is too much food in the Crisper Tray.
WHITE SMOKE COMES OUT OF THE APPLIANCE.
White smoke is emitted from the appliance.
The appliance contains grease residues from
previous use.
TO REPLACE FUSE: REMOVE
SILVER LABEL TO ACCESS
SCREW OR REMOVE COVER.
Solution(s)
Do not use the Air Fryer. Contact Dualit
Customer Services. Risk of fire.
Put the main plug in an earthed wall socket.
Adjust the settings to the required preparation
time to switch on the appliance.
Replace the 13 amp plug fuse if necessary and
check your residual current device (RCD).
Never use the plug without the fuse cover
fitted. Ensure replacement fuse is the same
current value as the original. Replacement
fuses are available and should be ASTA
approved to BS.1362.
Insert Crisper Plate into Crisper Tray by
aligning the arrows on one side of Crisper
Plate to point away from Crisper Tray handle.
Lower side without arrows into Crisper Tray
first. Then lower side with arrows to point
away from Crisper Tray handle.
Lower side without arrows into Crisper Tray
first. Then lower side with arrows to point
away from Crisper Tray handle.
Use the handle of a fork, positioned into one
of the slots, or a blunt kitchen utensil, and
prise the tray out.
Do not fill the Crisper Tray to capacity; ensure
there is a gap of 2cm from the top of the food
level to the top of the Crisper Tray.
Do not use the Air Fryer. Contact Dualit
Customer Services. Risk of fire.
White smoke is caused by grease heating up
in the Crisper Tray; ensure you are following
cleaning instructions on page 25 and that the
Crisper Plate and Crisper Tray are cleaned
thoroughly after each use.
27
Advertisement
Table of Contents
