Table of Contents
Advertisement
4. To remove the coin cell battery:
a. Using a plastic scribe press the release latch until the coin cell battery pops out [1].
b. Remove the coin cell battery from the connector on the system board [2].
Installing coin cell battery
1. Hold the coin cell battery with the "+" sign facing up and slide it under the securing tabs at the positive side of the
connector.
2. Press the battery into the connector until it locks into place.
3. Close the front panel door.
4. Install the:
a.
Expansion card
b.
Front bezel
c.
Side Cover
5. Follow the procedure in
Heat sink assembly
Removing heat sink assembly
1. Follow the procedure in
42
Field service information
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
