Hoover ONEPWR Emerge User Manual page 17

REMOVING AND CLEANING THE BRUSHBAR
(MODEL F18OPSV22J2)
NOTE:
If the brushbar or brushroll in the floorhead has been obstructed, the motor protection sensor may activate.
The brushes will stop and the machine may switch off. To reset, switch the machine off and remove the battery.
Remove the floorhead from the reach wand/handheld and clear any obstruction. Wait 1 minute before refitting the
floorhead. Install the battery and switch the machine on.
WARNING:
To reduce the risk of personal injury, always turn power switch off and remove battery before cleaning
or servicing.
Remove the floorhead from reach wand.
Using your fingers or a coin, push and
turn the brushbar lock anticlockwise to
release the brushbar.
Refit the brushbar into the housing and
turn the brushbar lock clockwise to lock.
CLEANING AND MAINTENANCE
Pull the brushbar out of the floorhead
with pull tab.
IMPORTANT:
For best
performance, regularly remove
any threads or hair from around
the brushbar.
To remove any threads or hair, cut along
the groove of the brushbar.
17